Page 1 of 1
cisco LNA BRAS PPPOE not working
Posted: 12 Mar 2020, 14:04
by miami1983
hi support,
we need to integrate HSNM with our LNS Cisco router as radius AAA
is there any custom configuration or attribute need to set because user unable to reach
thanks
Re: cisco LNA BRAS PPPOE not working
Posted: 12 Mar 2020, 15:25
by HSNMSupport
hi support,
we need to integrate HSNM with our LNS Cisco router as radius AAA
is there any custom configuration or attribute need to set because user unable to reach
thanks
Hi Miami,
we do only support Cisco WLC models.
You can try to set yours as a Cisco WLC but we can't confirm that will everything work.
It's not only a matter of attributes, but there are several configurations.
Have a nice day.
Re: cisco LNA BRAS PPPOE not working
Posted: 02 Apr 2020, 10:52
by miami1983
hi support,
we need to integrate HSNM with our LNS Cisco router as radius AAA
is there any custom configuration or attribute need to set because user unable to reach
thanks
Hi Miami,
we do only support Cisco WLC models.
You can try to set yours as a Cisco WLC but we can't confirm that will everything work.
It's not only a matter of attributes, but there are several configurations.
Have a nice day.
ok but does it work with rate-limit or i must use policy-map and add its attribute
thanks
Re: cisco LNA BRAS PPPOE not working
Posted: 02 Apr 2020, 11:11
by HSNMSupport
Hi Miami
We don't know because that kind of GW is not supported by HSNM and so we never tried it.
I suggest you to try without adding "custom attributes" on HSNM policy or user, and then if rate-limit will not work try adding the custom attribute inside HSNM
But remember that LNS Cisco router is not supported by HSNM
Best regards